To open a printable PDF version of this instruction CLICK HERE

The 3rz EGR valve removal is pretty straight forward. Remove the valve, install plates, cap off all vacuum lines associated with the EGR and you’re done with that side of it. The only other thing is to install a resistor in the harness that connected to the EGR Temp Sensor Plug (Pictured Below) The plug in the photo is not used and can actually be cut off. You will be installing the resistor in the harness that plugged into this sensor. We include 2 size resistors: Most will use the larger of the two, however the only way to know is to try one of them. They can be installed right into the harness and taped up, or once the proper resistor is determined, it can be soldered in, if preferred.

