To open a printable PDF version of this instruction CLICK HERE
Kit Contents:
- (1) - LCE EFI Low Pressure Fuel Gauge
- (1) - LCE Fuel Rail Block
- (1) - 90 Degree Elbow Fitting
- (2) - Washers M6
- (2) - M6 x 1.00 Bolts
- (1) - O-Ring For Fuel Block
When installing any gauge or fitting into the fuel rail bolt, the bolt will need to be secured by a wrench when installing any components, Otherwise damage may occur on the fuel rail bolt if it is not properly supported when additional parts are installed. Fuel Pressure bolt should be torqued to no more than 22ft lbs. Check and inspect for any leaks.
NOTE: LC recommends using fuel safe Teflon tape or Permatex Permasheild to prevent leaks from occurring when installing the product. This gauge is not intended to be left installed under hood. After every tune / use, remove gauge and install plug (supplied). Failure to remove gauge will result in gauge failure.
