Part# 1046200 – Rock Ripper Header Kit (Smog Legal)

1. Remove the heat shield covering the stock header. 2. If your truck is equipped with an air injection tube, remove the nuts that attach the header to the air injection crossover tube. Remove the two bolts attached to the air injection crossover tube located on the under-side of the front passenger side of the truck. Follow the air injection …

Part# 1042027 – Pro Flow Exhaust System Tacoma 1GR

LC Engineering has designed our Pro Flow Exhaust to fit any Tacoma 1GR Truck 2005-2012. It comes with a front pipe that is designed to be trimmed to the correct length for your cab or bed length. Please read and follow the directions completely to ensure proper fitment. NOTE: This system is designed to fit all cab and bed configurations. …

Part# 1041031 & 1041037 – LCE Header Kit – 1982-1995 22R/22RE 2WD & 4WD

Installation: Follow the steps in the service manual for disassembly and removal of exhaust manifold and header pipe. Remove bracket from bell housing that retains original header pipe. This bracket will not be re-used. Clean all gasket surfaces before installing gaskets provided in header kit. Install header. Tighten all fasteners to factory torque specifications. Some factory heat shields may need …

Weber Carburetor 32/36 Install Instructions

Weber 32/36 For Toyota 20/22R Carbureted Vehicles Thank you for purchasing a Weber carburetor conversion kit. Our kits are designed to unleash the performance of your engine, but not at the cost of reliability and fuel efficiency. This installation guide covers vehicle preparation, old carburetor removal, carburetor installation, and new carburetor adjustments. There’s also a trouble-shooting guide, if needed. NOTE: …