Part# 1053126 – Gold Star Clutch

The Gold Star Clutch and Flywheel assembly is the ultimate for circle track racing. If worn, replace transmission pilot bearing (worn bushings or bearing can cause transmission failure and clutch drag!) The center diaphragm in the center of the clutch where the throw-out bearing rests should be (collapsed diameter 1.845”) (open diameter 2.120”). Recommended throw-out bearing sizes: inside diameter 1.745” …

Part# 1052009-1052016 – Wear Pad Torque Specs. (For LC Aluminum Flywheels)

LC Engineering always recommends changing your wear pad and hardware whenever you change clutches. The hardware may need to be machined out of the flywheel due to the locking nuts and extreme heat caused by the clutch. Torque new nuts to 29 inch pounds. Always torque nuts in a star pattern around the flywheel to ensure even torque load.

Part# 1051002 – 3RZ 12lb Billet Aluminum Flywheel (Lightweight)

Rev. It Up!!! Install you new lightweight billet aluminum flywheel and watch the tach climb faster than ever! When installing you new flywheel you will notice we supply a small steel ring. This ring keeps the bolts heads from damaging the aluminum center. Be sure to install this ring on the pressure plate side of the flywheel (Do not install …